Aquascape 300 Watt Pond Deicer

Large, low-profile pond de-icer resists tipping against blustery winter winds. The unique design of the Pond Saucer minimizes heat loss due to frigid winds for reliable performance. Maintains a vent hole in the ice to ensure proper gas exchange throughout the winter. Thermostatically-controlled de-icer operates only when necessary for reliable energy-efficient performance turns on automatically at 35F and turns off when the water temperature is at 45F. Made from easy-to-clean, weather resistant thermoplastic material. 200 watts. 12-1/2" diameter and only 1-3/4" high. 10 ft power cord

NOTE: Mineral build-up can affect the performance of the de-icer and is not covered under the manufacturer warranty. Deicers will ship via USPS

The PondMaster 120 watt Pond Deicer is ideal for ponds up to 2000 gallons. This is one of the most energy efficient de-icers on the market and is thermostatically controlled to reduce heating time and save energy. The doughnut design maintains an ice-free center allowing harmful gas to escape from your pond. The internal electronics are epoxy sealed for extra watertight protection. Unit comes with an 18 foot cord and will not harm liners or preform ponds. *The actual pond size may vary (larger or smaller) depending on your geographical region and winter temperatures.

NOTE: Mineral build-up can affect the performance of the de-icer and is not covered under the manufacturer warranty. Deicers will ship via USPS.

Perfect Climate pond de-icer perfect for small or large ponds. Energy efficient unit can be used as a floating or submersible de-icer to maintain an area of open water in ponds during winter. Specially designed thermostat minimizes wear for reliable use, year after year. Thermostatically controlled de-icer operates automatically once temperature falls. All heating elements are enclosed to protect pond inhabitants and pond liner. 12-foot cord.

NOTE: Mineral build-up can affect the performance of the de-icer and is not covered under the manufacturer warranty. Deicers will ship via USPS. All warranties are handled through the manufactuer. The number you can reach them is 719-591-6950

Perfect Climate Deluxe 1500 Watt Pond De-Icers

Perfect Climate pond de-icer perfect for small or large ponds. Energy efficient unit can be used as a floating or submersible de-icer to maintain an area of open water in ponds during winter. Specially designed thermostat minimizes wear for reliable use, year after year. Thermostatically controlled de-icer operates automatically once temperature falls. All heating elements are enclosed to protect pond inhabitants and pond liner. 12-foot cord.

NOTE: Mineral build-up can affect the performance of the de-icer and is not covered under the manufacturer warranty. Deicers will ship via USPS. All warranties are handled through the manufactuer. The number you can reach them is 719-591-6950

Allied Precision Industries Pond Breather

Assembly:

• Carefully remove the unit from the box. The Cap, Gas Exchanger, Float, and Ice Guard should all be connected via the Tubing and Heater Cord that passes through them from the Cap to the Pump.
• Slide the Float up the tubing and over the end of the Gas Exchanger. The Float is notched so the tabs on the end of the Gas Exchanger will pass through it,
• Next, slide the Ice Guard up so the Cap engages the tabs on the bottom of the Gas Exchanger. Rotate the Ice Guard to lock it in place.
• The Pond Breather is now assembled. If for some reason, the Pump Screen is not attached, simply fold the cords around the pump and snap together the Pump Screen halves with all cords and tubing exiting through he large hole.

Operation:

Install the Pond Breather in open water. It should float vertically. The Pump Screen can either lie on the bottom of the pond or, in deep water, it will hang suspended by the tubing. The Pond Breather operates on 120 volts and is supplied with a 15 foot cord that should be plugged into a Ground Fault Circuit Interrupter (GFCI). When plugged in, you should see water start to flow through the Gas Exchanger.

During operation, ice may form on top of the Float from water that exits the overflow hole near the bottom of the Gas Exchanger. This is normal, do not remove the Heater Cord from the overflow hole or plug the hole in any way.

Maintenance:

The Pond Breather is designed to operate practically maintenance free. However, to maintain optimum performance you should do the following:

• Make sure the Pump Screen is located where it will not become clogged with leaves or mud.
• Keep the Cap clear of snow so air can enter the Gas Exchanger.
• Make sure the Heater Cord runs down the outside of the Gas Exchanger and enters the overflow hole. Make sure the overflow hole is not blocked.

Troubleshooting

1. Unit is plugged in but no water is running.
   • Check to see that electricity is being provided to the unit and that the GFCI has not been tripped.
   • Look closely to make sure that the unit is running. Sometimes the water movement within the Gas Exchanger can be hard to see.
   • The Tubing may have become disconnected from the pump. Open the Pump Screen and reconnect the Tubing if necessary.
   • The power may have gone off and there is frozen water in the unit. If so, the unit should thaw and resume operation within 2 hours after electric power is restored.
2. The Heater Cord on the outside of the Gas Exchanger feels hot.
   • This is normal. The cord puts out 25 watts of heat and should feel warm or hot to the touch.
3. Icicles are hanging down the side of the Gas Exchanger.
   • Check that the overflow hole in the lower portion of the Gas Exchanger is open. Check the Heater Cord to make sure it feels warm and is entering through the overflow hole.
4. The unit keeps tripping the Ground Fault Circuit Interrupter (GFCI).
   • The unit is defective and, if under warranty, should be returned.
5. Ice is building up on top of the Float and around the Gas Exchanger.
   • This is part of normal operation.

The Ice Eliminator's low contour and neutral color looks great in any birdbath. Using only 50 watts, it maintains open water to -20 Fahrenheit and is even safe to use in plastic birdbaths. Made of aluminum, it will not rust, "lime-up" or float. 18" cord, Thermostatically controlled. 1 year limited warranty. Approx 6"long and 2.5"wide

NOTE: Mineral build-up can affect the performance of the de-icer and is not covered under the manufacturer warranty. Deicers will ship via USPS. All warranties are handled through the manufactuer. The number you can reach them is 719-591-6950

Kasco D Series De-Icers

FREE SHIPPING!